F8 - Daily Maintenance and Storage

Time : 2022-09-26 Hits : 39

First, Set the On/Off button to Off " o " position, then plug in the socket. Push the On/Off button to turn on the machine. Press the LED display screen to choose suitable wind heat, suitable wind speed and mode.(Figure 1,Figure 2)

Memory function: when device is turned on for the first time, its original mode is high heat and high speed. When it is turned on from second time, it stays in the same mode as previous use.

Notes:

1.During use do not touch high temperature golden aluminum sheet to avoid scald.
2.Keep the position of holding the handle upward to avoid blocking the inlet mesh and affecting the air inlet effect.

The products is equipped with quick connect 2-in-1 nozzle and diffuser nozzle ,which can spin in 360°(Figure 3).2-in-1 Nozzle can push the push button to adjust the air volume:Figure 4 shows high speed air volume, push the button upward to reduce air volume. Diffuser nozzle is with built-in rotatable fan blades to create more even air flow.
Please install the nozzle under the switch-off status, do not disassemble the nozzle during device working to avoid scald. After using, remove the nozzle until it cools down to avoid scald.
When the device is equipped with nozzle, when the device is working in warm mode, do not push the push button and touch the nozzle to avoid scald.

Please keep the distance of more than 10cm between hair and air inlet, to avoid hair from entangling into the hair dryer. Please keep the distance of more than 3cm between hair and air outlet to avoid scald.
After using, turn off the device and unplug the power cord.

Maintenance and Storage

Please make sure the button is in the Off position and then unplug the socket during cleaning.
Please regularly use the towel, cotton bud or tooth brush to clean the inlet and outlet.And Rotate down inlet metal network to clean the filter screen.
Please do not use nail or sharp articles to press and rub the inlet and outlet to avoid products damage.
Please do not use alcohol, nail polish remover or detergent to clean the products, otherwise, it will cause failure, crack or colour fading.

Safety Notes

Please read this instruction manual carefully before use, properly save and store it for future use.

Please use the voltage and electric current as described on the rating label.

Please do not block the outlet and inlet, otherwise, it will cause scald, electric shock or fire due to short circuit.

Please do not use the hair dryer when the hands are wet, otherwise, it will cause electric shock and fire caused by short circuit.

Please do not unplug the power plug when the hands are wet, otherwise, it will cause electric shock and injury.

When the hair dryer is used in the bathroom, unplug it after using, even though the hair dryer is powered off, it is still dangerous when it is close to water.otherwise it might cause accidents or damages.

Please do not use hair dryer next to bath tub, shower, lavatory or other utensil etc.

Please do not use the products when the power line is entangled, otherwise it will cause electric shock or fire due to short circuit.

Please do not use the machine near to petroleum gas or other inflammable (like propellant, paint thinner, spray etc.), otherwise it will cause explosion.

Please do not leave the power on when the machine is not used, otherwise it will cause fire due to short circuit.

Please do not entangle the power line around the main machine, otherwise it will cause power cut and cause electric shock or fire due to short circuit.

Please keep out reach of children and infants to avoid electric shock and injury.

Please do not put the inlet downwards during working, otherwise it will cause thermal fuse red and cause fire.

Please do not damage, refit, bend hardly, pull,twist the power line, or put anything on the power cord, squeeze the power line, otherwise it will cause electric shock or fire due to short circuit.

The outlet and nozzle will get hot during using, please do not touch it to avoid getting hurt.

If the smell of protein burning occurs during use, it may be caused by the hair debris entering the hair dryer with the wind. After normal use for a period of time, the odor will dissipate automatically and will not affect normal use.

Prevent the fan from falling down or from getting strike, otherwise it will cause electric shock or fire due to short circuit.

Please avoid to use it when the inlet is damaged, otherwise hair might be drawn into inlet, causing hair damage.

Please unplug the socket immediately, please do not immerse your hand into the water if the machine is accidentally fallen into the water.

For additional protection,It is recommended to install a residual current device (RCD) with rated current not exceeding 30mA when using electrical products, so as to avoid fire accidents and personal hazards caused by leakage. Ask your installer for advice.

Please do not use it If it is not plugged in tightly, otherwise it will cause, scald, electric shock or fire due to short circuit.

Clean the socket regularly to prevent dust from accumulating, otherwise it will cause insulation fault due to humidity, eventually causing fire. Disconnect the power immediately and clean it with dry cloth.

Please make sure that hold the power plug and do not drag the power cord and make when unplugging the power plug.Otherwise,the power cord may be broken,scald, electric shock or fire due to short circuit.

Please stop using the machine If you see the fire in the outlet during hot wind mode, clean the dust in the inlet and outlet, otherwise it might cause scald or fire.

Please do not store the power line when it is twisted, otherwise it will cause power line cut, which might cause scald, electric shock or fire due to short circuit.

The product is only for the use of drying hair, please do not use to dry shoes or clothes etc., otherwise it will cause electric shock or fire due to short circuit.

Please keep the distance of more than 10cm between hair and inlet,avoiding hair from entangling into the hair dryer.

Please keep the distance of more than 3cm between hair and outlet to avoid scald.

The hair dryer is equipped with overheating protection system, the power will be cut when it is over-heated.And switch off and unplug immediately, let it cool down for a minutes. Check if there is some fluff or hair in the inlet or outlet, then switch on again.

Please make sure to adjust to "off" after using, unplug from the socket, otherwise it might cause scald or fire.

If the power line is damaged, which must be replaced by professional staff from local agents.

Note: This sign means Forbidden to use it during bath or shower.